PRODUCT DESCRIPTION

FEYNLAB® A50 SUPER HEAVY CUTTING COMPOUND is the most sophisticated cutting compound in the automotive paint & refinish markets.

FEYNLAB® A50 SUPER HEAVY CUTTING COMPOUND contains the most advanced ceramic aluminum-oxide technology. These abrasives are incredibly hard and microscopically sharp compared to the competition. This means more cut, less diminishing of abrasives, and less product used compared to the competition.

FEYNLAB® A50 SUPER HEAVY CUTTING COMPOUND was specifically developed to compound and remove swirls and even deeper scratches from clear coated automotive painted surfaces, while leaving a superior clarity on the surface.

PRODUCT BENEFITS

• Effortless removal of even the deepest surface imperfections, including 1000 grit sand marks
• Perfect for heavily scratched painted automotive finishes prior to FEYNLAB® coating
• Fast and consistent cut
• Cost saving as less product is needed when compared against the
• Simple & quick wipe off

APPROVED SURFACES
APPROVED SURFACES FOR APPLICATION ONLY – DO NOT apply to unapproved surfaces*

• Clear Coated Painted Surfaces
• Single stage paint surfaces
• Gel-coated surfaces

*The use of Feynlab products on any surface not explicitly listed in the instructions booklet is done at the user's own risk. If damage occurs to the surface as a result of using the product on an unlisted surface, we will not be held liable for any such damage.


INCLUDED
1 kg or 5 kg of FEYNLAB® A50 SUPER HEAVY CUTTING COMPOUND


CAUTIONS
We encourage the use of gloves, an approved face mask and eye protection when using any compounds or polishes.


PREPPING THE SURFACE

• Place vehicle in a well-lit, cool, & contamination free environment
• Remove all excessive surface dirt and contaminants using either PURE WASH or PURE RINSELESS
• Clay the surface to remove any surface bonded contaminants

ROTARY POLISHER DIRECTIONS

• Shake the bottle vigorously for 1 minute before use. Regularly, give the bottle a few shakes during each compounding
• Prepare the wool pad by placing 4 dime size dots and spread around on the face of the pad. Then place 4 dime size dots on the face of the pad and spread around area to be
• In general, begin with a 2 x 2-foot section. Decrease working area if heavier correction is
• Using a speed of no more than 1600 rpm, make 2 – 4 slow passes over the given
• Wipe clear with a clean microfiber
• Check your results from multiple angles to ensure complete removal of
• Although A50 can be used as a final polish, Feynlab highly recommends a final polish with a DA Polisher to remove and rotary trails that may be left behind.
• Admire your Take lots of pictures. Brag about it to your friends and give the FEYNLAB® team a virtual high five.

DUAL-ACTION (DA) POLISHER DIRECTIONS

• Shake the bottle vigorously for 1 minute before use. Regularly, give the bottle a few shakes during each compounding
• Prepare the microfiber or foam pad by placing 4 dime size dots and spread around on the face of the pad. Then place 4 dime size dots on the face of the pad and spread around area to be
• In general, begin with a 2 x 2-foot section. Decrease working area if heavier correction is
• Using a speed of 3400 – 4000 opm, make 2 – 4 slow passes over the given
• Wipe clear with a clean microfiber
• Check your results from multiple angles to ensure complete removal of
• Admire your Take lots of pictures. Brag about it to your friends and give the FEYNLAB® team a virtual high five.

SHELF LIFE
1 year in a normal, climate-controlled environment.